Model 12LT is the smallest trailer in our range and the only one with a single axle, suitable for calves, sheep and pigs. Model 30LT is the smallest that will accommodate two cattle. Models 40LT and 42LT are longer with increased carrying capacity, all the trailers have a fully galvanised chassis's and frame with full Avonride independent rubber suspension axles and 203 x 40 auto reversing brakes, 13" styled wheels and radial tyres. All have a side inspection door, one piece alloy treadplate floor and folded aluminium ramp with ramp side gates. Model 40HB is available with 7' headroom and a timber ramp to accommodate horses if required. The trailer can be supplied without lower vents and with a breast bar and divider panel.
Removable decks and cross divisions are available for all models except 12LT.

These trailers are designed for use with 4-wheel drive and similar vehicles and are available 3m or 3.6m long, 1.5m or 1.7m wide.  All have Landrover wheels, galvanised chassis's and frame, one piece alloy treadplate floor, folded alloy ramp with ramp side gates, full width Avonride axles with independent rubber suspension and auto reversing brakes. Removable decks and cross division gates can be fitted if required.  The maximum permitted pen lengths are 3.7m for cattle, 3.1m for pigs and sheep and 2.5m for calves.
All trailers are panelled with toughened alloy and have plastic coated galvanised steel roofs. Standard equipment includes a front jockey wheel and ramp lifting springs. Models 45HB and 48HB are available with 2.13m headroom and with timber ramps to also enable them to be used for horses.

Models 50LT and 60LT have a 1.8m high removable livestock container and are fully galvanised.  The chassis has deep section channel runners and a profiled drawer, full width galvanised Avonride 185-70 x 13 trailer tyres and 5 stud wheels. Four de-mounting jacks can be supplied as an option to assist the removal of the container complete with the ramps and gates, leaving a flat Platform trailer with the one piece aluminium treadplate covered floor.

Eurostock livestock trailers have been designed to incorporate optional integral folding decks which can be completely folded for storage within 30 seconds and have no loose parts.  90cm clearance is provided on both decks to accommodate calves and large sheep with adequate headroom.   The rear section of the right hand panel lowers to form a low angle ramp for loading the top deck.  The left hand ramp side gate can be re-positioned in the centre if required to load the top deck only.  Ventilation is provided by the front louvre ventilator and two rows of large flexible slides each side of the trailer. A roof rack is incorporated to carry light loads, fodder or hurdles with a ladder on the rear door for access and stock inspection.  Full width Avonride rubber suspension axles are fitted with 250 x 40 auto reversing brakes and Landrover wheels.

Models 90LT and 100LT livestock trailers are designed for use with agricultural tractors. The chassis is derived from our range of agricultural trailers are are fitted with twin beam axles with cam brakes, hydraulically operated from the tractor and leaf spring suspension. The demountable containers are fully galvanised and are fitted with a side inspection door and one cross division gate as standard. The floors are covered with treadplate aluminium and have four corner sockets into which optional harvest ladders can be fitted. A 1.2m long extension is also available to increase the platform length for carrying bales if required.